BRONZ-GLOW®

Specializing in Corrosion Control for Air Conditioning Coils,
Cabinets, Ducting, Insulation and Structural Steel, Concrete
and Other Commmercial Applications

Bronz-Glow
   
Home Products Services Tech Data / Questions Warranty Case Histories Licensing
   
   
  Bronz-Glow® Glow® F-905 (was Bronz-Glow F-905)
Urethane Water Base Coating
Versatile, Emissions Control Coating
APPLICATION DATA
(905/5/04)
Bronz-Glow® F-905 Product Data
Bronz-Glow® F-905 MSDS
< Return to Products

SURFACE PREPARATION:
· Remove all traces of oils, grease, rust, dirt, and dust
· A sandblasted or rough surface improves adhesion for non-decorative metals
· For decorative metals, remove oil, wax, dirt, grease, and oxides
· Apply coating directly over decorative metal surface

Preparing surfaces exposed to high salt conditions
· Sandblast or wire brush metal surfaces to remove all rust and oxides
· Pressure wash with a free-rinsing, high pH cleaner - – Bronz-Glow Heavy-Duty Alkaline Cleaner is recommended
· Pressure rinse with clean water
· Pressure wash to reduce surface pH to 3.5-5.0 - Bronz-Glow Heavy-Duty Acid Cleaner is recommended
· Allow to dry thoroughly

Preparing Steel Surfaces
· Abrasive blast to SSPC SP-5/NACE No. 1 or Swedish Standard Sa 3.
· Prime using Husky F-915 or F-250 Primer

Prparing Concrete surfaces
· Clean, abrasive blast, or etch with 10 per cent muriatic acid
· Prime with Bronz-Glow F-915 Acrylic Primer

RECOMMENDED EQUIPMENT AND SETTINGS:
Conventional and Air Assist Spray Equipment
Gun:
Binks model 2001 gun or Graco model 95 gun
Nozzle: 63B
Cap: 63PB or 66SD-3 for heavier build-up
Needle: 63-A
Pressure at Pot 15-25 psi
Pressure at Gun: 25-40 psi
Dilution: Not required
Clean-up: Water (if dried use Acetone or MEK)
Airless Spray Equipment
Tip Sizes: .011-.026
Pressure: As needed
Dilution: Not required
Clean up: Water (Acetone or MEK if dried)

Always provide ventilation and use approved personal safety protection when handling or applying coatings.

Government Specifications:
Bronz-Glow Is Specified by numerous agencies of the U.S. government.

CONDITIONS OF USE:
Read Bronz-Glow's Condition Of Use Statement

Go To:
Bronz-Glow® F-905 Product Data
Bronz-Glow® F-905 MSDS
< Return to Products

For more detailed information call, email, or refer to our other Technical Data on this site.

Bronz-Glow, Husky & Logo are Registered Trademarks of Bronz-Glow Holdings, St. Augustine, FL

 

 

Home Products Services Tech Data / Questions
Warranty Case HistoriesLicensing
About Us Contact Us Hot Links

© Bronz-Glow Holdings 2003

 
Located in N.E. Florida
Serving Southern Georgia, Florida, Domestic U.S. & International Firms