Bronz-Glow® F-860 Clear
Protective Coating
(was Husky 815 Spc Clear)
A Tough Coating for HVAC/R & Commercial Application
Safely Coats Over Decals, Labels, Stencils &
Permanent Marker Without Distortion
SURFACE PREPARATION:
· Pressure wash using mild detergent, removing any heavy
dirt, bird droppings, grease or oil
· Using 50/50 water/alcohol mix on painted surfaces remove
all traces of oils, grease, dirt, and dust by hand wiping
PREPARING RUSTED BARE STEEL OR GALVANIZED SURFACES:
· Sandblast or wire brush metal surfaces to remove all
rust and oxides
· After sandblast or wire brushing, pressure wash with a free-rinsing,
high pH cleaner - Bronz-Glow Heavy-Duty Alkaline Cleaner is
recommended
· Pressure rinse with clean water
· Pressure wash to reduce surface pH to 3.5-5.0 – Bronz-Glow
Heavy Duty Acidic Cleaner is recommended
· Allow to dry thoroughly
ABRASIVE BLAST:
· Abrasive blast to SSPC SP-5/NACE No. 1 or Swedish Standard
Sa 3.
PREPARING CONCRETE SURFACES:
· Clean, abrasive blast, or etch with 10 per cent muriatic
acid
· Prime with Bronz-Glow F-915 Acrylic Primer
| RECOMMENDED EQUIPMENT AND SETTINGS: |
| Conventional and Air Assist Spray
Equipment |
Gun:
|
Binks Model 2001 gun or Graco
model 95 gun |
| Nozzle: |
63B |
| Cap: |
63PB or 66SD-3 for heavier build-up (Do
not dilute) |
| Needle: |
363A |
| Material: |
15-25 psi |
| Atomization: |
25-40 psi |
| Dilution: |
Not required |
| Clean-up: |
Bronz-Glow 15 or 25 Reducer |
| Airless Spray Equipment
|
| Tip Sizes:
|
.010-.015 |
| Pressure: |
As needed |
| Dilution: |
Not required |
| Surface Test: |
Painted surfaces may lift. Test a small
area before applying over a painted finish |
Always provide ventilation and use approved personal safety
protection when handling or applying coatings.
Government Specifications:
Bronz-Glow Is Specified
by numerous agencies of the U.S. government.
CONDITIONS OF USE:
Read Bronz-Glow's Condition
Of Use Statement
Go To:
Bronz-Glow®
F-860 Product Data
Bronz-Glow® F-860 MSDS
< Return to Products
For more detailed information call, email, or refer
to our other Technical
Data on this site.
Bronz-Glow, Husky & Logo are
Registered Trademarks of Bronz-Glow Holdings, St. Augustine,
FL
|
