Bronz-Glow® F-915 Acrylic Primer
Superior Adhesion for Metal Surfaces
SURFACE PREPARATION:
· Remove all traces of oils, grease, rust, dirt, and dust
· A sandblasted or rough surface improves adhesion
· Use Husky 15 or 25 Reducer for clean up or thinning
Preparing surfaces exposed to high salt conditions
· Sandblast or wire brush metal surfaces to remove all
rust and oxides
· Pressure wash with a free-rinsing, high pH cleaner - Bronz-glow
Heavy-Duty Alkaline Cleaner is recommended
- Bronz-Glow Heavy-Duty Alkaline Cleaner is recommended · Pressure rinse with clean
water
· Pressure wash to reduce surface pH to 5.0-7.0 - Bronz-Glow
Heavy-Duty Acidic Cleaner is recommended
· Allow to dry thoroughly before applying F-915 Primer
Additional surface preparation
· Abrasive blast steel to SSPC SP-5/NACE No. 1 or Swedish
Standard Sa 3.
· Clean concrete with abrasive blast, or etch with 10 per
cent muriatic acid
Previously finished surfaces
· Repair all damaged areas
· Remove gloss from previous coating by sandblasting or "brush
blasting"
· Remove rust, corrosion products, heavy chalk, and peeling
· Spot prime bare areas
| RECOMMENDED EQUIPMENT AND SETTINGS: |
| Conventional and Air Assist Spray
Equipment |
Gun:
|
Binks Model 2001 gun or Graco
model 95 gun |
| Nozzle: |
63B |
| Cap: |
63PB or 66SD-3 for heavier build-up (Do
not dilute) |
| Needle: |
363A |
| Material: |
15-25 psi |
| Atomization: |
25-40 psi |
| Dilution: |
Not required |
| Airless Spray Equipment |
| Tip Sizes: |
.011-.015 |
| Pressure: |
As needed |
| Dilution: |
As required |
| Surface Test: |
Painted surfaces may lift. Test a small
area before applying over a painted finish |
Always provide ventilation and use approved personal safety
protection when handling or applying coatings.
Government Specifications:
Bronz-Glow Is Specified
by numerous agencies of the U.S. government.
CONDITIONS OF USE:
Read Bronz-Glow's Condition
Of Use Statement
Go To:
Bronz-Glow®
F-915 Primer Product Data
Bronz-Glow® F-915 Primer MSDS
< Return to Products
For more detailed information call, email, or refer
to our other Technical
Data on this site.
Bronz-Glow, Husky & Logo are
Registered Trademarks of Bronz-Glow Holdings, St. Augustine,
FL
|
